How To Replace Grout Between Floor Tiles

Grout is a crucial component of any tiled surface, as it fills the spaces between tiles and helps to keep them in place. Over time, however, grout can become discoloured, cracked, or damaged, which can make your floor look unsightly. If you're looking to refresh the look of your tiled floor, replacing the grout is a great place to start.

Replacing grout is a relatively simple task that can be completed in a few hours. However, it's important to take your time and do the job properly to ensure that your new grout lasts for many years to come.

Materials You'll Need:

New grout
Grout float
Grout sponge
Bucket
Water

Instructions:

Remove the old grout. Start by removing the old grout using a grout saw or a utility knife. Be careful not to damage the tiles.
Clean the joints. Once the old grout has been removed, clean the joints between the tiles using a damp sponge. This will help to remove any dust or debris that could interfere with the new grout.
Mix the grout. Mix the new grout according to the manufacturer's instructions. The grout should be mixed to a thick, creamy consistency.
Apply the grout. Using a grout float, apply the grout to the joints between the tiles. Be sure to press the grout firmly into the joints.
Smooth the grout. Once the grout has been applied, smooth it out using a grout float. The grout should be flush with the surface of the tiles.
Let the grout dry. Allow the grout to dry for 24 hours. Once the grout has dried, you can remove any excess grout from the surface of the tiles using a damp sponge.
Seal the grout. Once the grout has completely dried, seal it using a grout sealer. This will help to protect the grout from stains and damage.

Tips:

Use a grout saw or a utility knife to remove the old grout. This will help to prevent damaging the tiles.
Clean the joints between the tiles using a damp sponge. This will help to remove any dust or debris that could interfere with the new grout.
Mix the grout according to the manufacturer's instructions. The grout should be mixed to a thick, creamy consistency.
Apply the grout using a grout float. Be sure to press the grout firmly into the joints.
Smooth the grout using a grout float. The grout should be flush with the surface of the tiles.
Let the grout dry for 24 hours. Once the grout has dried, you can remove any excess grout from the surface of the tiles using a damp sponge.
Seal the grout using a grout sealer. This will help to protect the grout from stains and damage.

By following these steps, you can easily replace the grout between your floor tiles and give your floor a fresh, new look.