How To Replace Broken Tile In Bathroom Floor

How to Replace Broken Tile in Bathroom Floor: A Comprehensive Guide

A broken tile in your bathroom floor can be an eyesore and a safety hazard. Luckily, replacing a broken tile is a relatively easy home repair project that you can complete in a few hours. Here's a step-by-step guide to help you get the job done:

Gather Your Materials

Before you begin, gather the following materials:

Replacement tile
Tile adhesive
Notched trowel
Grout
Grout float
Caulk gun
Utility knife
Safety glasses
Rubber gloves
Damp sponge

Remove the Broken Tile

Put on your safety glasses and gloves. Carefully remove any loose or broken pieces of tile from the floor. Use a utility knife to score around the perimeter of the broken tile, then use a hammer and chisel to chip away at the tile until it comes loose. Be careful not to damage the surrounding tiles.

Prepare the Surface

Once the broken tile is removed, clean the area thoroughly with a damp sponge. Allow the surface to dry completely. Then, apply a thin layer of tile adhesive to the area where the new tile will be installed. Use a notched trowel to create ridges in the adhesive, which will help to hold the tile in place.

Install the New Tile

Carefully place the new tile into the adhesive. Press down firmly on the tile to ensure that it is level with the surrounding tiles. Use a damp sponge to remove any excess adhesive from the surface of the tile.

Grout the Tile

Mix the grout according to the manufacturer's instructions. Apply the grout to the joints between the tiles using a grout float. Hold the grout float at a 45-degree angle and press the grout into the joints. Remove any excess grout from the surface of the tiles with a damp sponge.

Caulk the Edges

Once the grout has dried completely, apply a bead of caulk around the edges of the tile. Use a damp sponge to smooth out the caulk and remove any excess. This will help to prevent water from seeping into the joints and damaging the floor.

Let the Floor Dry

Allow the floor to dry completely before walking on it or using the bathroom. The drying time will vary depending on the type of adhesive and grout that you used.