How To Replace Broken Tile In Shower Floor Singapore Homewyse

How to Replace Broken Tile in Shower Floor Singapore Homewyse

Replacing broken tiles in your shower floor can be a daunting task, but it's one that can be tackled with a little preparation and the right tools. Here's a step-by-step guide to help you through the process.

Tools and Materials You'll Need:

Safety glasses
Respirator mask
Hammer or chisel
Tile cutter
Thin-set mortar
Grout
Grout float
Sponge
Bucket
New tile(s)

Step 1: Safety First

Before you start, put on safety glasses and a respirator mask to protect yourself from dust and debris. Also, make sure the area is well-ventilated.

Step 2: Remove the Broken Tile(s)

Using a hammer or chisel, carefully remove the broken tile(s). Be careful not to damage the surrounding tiles.

Step 3: Prepare the Surface

Once the broken tile(s) are removed, use a wire brush to clean the surface of any debris or old mortar. Then, apply a thin layer of thin-set mortar to the area where the new tile(s) will be installed.

Step 4: Cut the New Tile(s)

Use a tile cutter to cut the new tile(s) to the correct size. Make sure the edges are smooth and even.

Step 5: Install the New Tile(s)

Apply a thin layer of thin-set mortar to the back of the new tile(s). Then, carefully place the tile(s) in the desired location. Use a rubber mallet to gently tap the tile(s) into place.

Step 6: Grout the Tile(s)

Once the tile(s) are installed, apply a thin layer of grout to the joints between the tiles. Use a grout float to smooth out the grout and remove any excess.

Step 7: Clean Up

Once the grout has dried, use a damp sponge to clean up any remaining debris. Make sure to rinse the sponge frequently to avoid smearing dirt on the tile(s).

Tips:

If you're not sure how to cut tiles, you can rent a tile cutter from your local hardware store.
When mixing thin-set mortar, follow the manufacturer's instructions carefully.
Don't apply too much grout to the tile joints. This can make it difficult to clean up.
Allow the grout to dry completely before using the shower.

Conclusion:

Replacing broken tiles in your shower floor is a relatively simple task that can be completed in a few hours. By following the steps outlined in this guide, you can save yourself the cost of hiring a professional.